Excellent destabilization effect and ideal desorption temperature in the hydride Mg2FeH6 substituted with yttrium; a first principles study

We investigated some properties of the hydride Mg₂FeH₆ substituted with yttrium by a first principles calculation. Some experimental results showed that 4d transition metal, yttrium serves as a good catalyst for magnesium based hydrogen storage alloys, but there are a few theoretical studies about magnesium based hydrides substituted with it. Mg₂FeH₆ is regarded as a cheaper material than pure MgH₂, while it is crystalized into Fm3m structure (space group 225). Although it has high hydrogen storage capacity, many investigations have not been devoted to it due to its extremely high thermodynamic stability. The yttrium substituted Mg₂FeH₆ exhibits very low energy of formation, and its desorption temperature, 75 °C is very suitable for practical hydrogen storage applications. Our results showed that Mg₂FeH₆ is destabilized effectively by yttrium substitution and introducing vacancy defects has additive effect to the improvement of dehydrogenation performance.     

胡萝卜丁中维生素C在热风辅助射频干燥过程中降解的动力学模型

目的研究热风辅助射频(hot air-assisted radio frequency,HA-RF)干燥过程中维生素C随温度变化的降解动力学模型。方法在6.5 cm极板间距和60℃热风系统条件下进行HA-RF干燥,重点研究胡萝卜丁中维生素C在干燥过程中的降解动力学,包括脱氢抗坏血酸(dehydroascorbic acid,DHAA)和抗坏血酸(ascorbic acid,AA)。总维生素C含量采用2,4-硝基苯肼分光光度法测定,AA采用2,6-二氯吲哚酚滴定法测定。结果HA-RF干燥过程中维生素C的降解规律符合一级可逆模型,其降解活化能为40.54 kJ/mol。DHAA活化能为35.83 kJ/mol,表明DHAA的稳定性低于AA。结论本研究使用的干燥温度为62.5~77.5℃,较高的干燥温度下维生素C降解速率较高,较低处理温度下的降解过程具有更好的模型适应度(R2>0.98)。     

Young’s modulus evolution during heating,re-sintering and cooling of partially sintered alumina ceramics

The Young modulus of partially and fully sintered alumina ceramics, obtained by firing to different temperatures (range 1200–1600°C), has been determined via impulse excitation, and the evolution of Young’s modulus of partially sintered alumina with temperature has been monitored from room temperature to 1600°C. As expected, the room-temperature Young modulus of the partially sintered materials is lower than all theoretical predictions. With increasing temperature Young’s modulus decreases, until the original firing temperature is exceeded and sintering (densification) continues, resulting in a steep Young’s modulus increase. During heating and cooling the temperature dependence obeys a master curve for alumina, unless the temperature of the original firing is excessively low.     

Adaptive switching control based on limited multiple models

In this paper, the limited multiple models system identification scheme with third‐level adaptation is proposed to build the virtual identification model for the control of the closed‐loop system. First, the dynamical switching identification models subbank is constructed based on the performance index. Next, the virtual identification model is build through the combination of the identification models in the dynamical switching subbank. Then, the combination proportion of the models is adaptively tuning with the third‐level adaptation. The main contribution of this paper is that the proposed dynamical system identification method can overcome system resources waste of the multiple models switching with second‐level adaptation, and it does not require that all of the identification models combine directly. Finally, the simulation is provided to illustrate its effectiveness.     

基于约瑟夫森量子电压的交流功率测量系统及方法研究

基于约瑟夫森量子电压标准设计了交流功率差分测量系统。通过分析差分采样系统的误差分布及误差传递函数,提出换向差分测量方法,减小了差分采样系统的增益误差,提高了电压幅值测量准确度;通过分析衰减系数η,证明了采用换向差分测量较容易实现10-7量级电压幅值测量。通过评估差分采样系统零相位,结果证明了差分采样系统具有较好的相位测量稳定性。分析了交流功率差分测量系统的不确定度分量,评估了功率因数为1.0,0.5 L和0.5 C时的功率测量不确定度,通过与国家交流功率基准装置进行实验比对,证明了基于约瑟夫森量子电压交流功率测量系统不确定度评估的合理性。     

应用变频器技术实现SO2风机节能改造

铜目前,硫酸车间制酸一系列共有三台SO2风机,这三台风机均采用液力耦合器的调速方式,这种方式可以实现无极调速,但是存在着传动效率低,耗能大的缺点,并且这三台风机均已使用20年以上,处于设备的中晚期,工作效率已大大降低。目前行业内,均采用先进的变频调速方式。使用变频器来控制风机的转速,可以极大的节省电能,尤其是在低负荷情况下,可以实现低转速运转,大大提高硫酸系统的综合能耗指标。     

Complete Photochemical Regulation of 8–17 DNAzyme Activity by Using Reversible DNA Photo-crosslinking

The regulation of DNAzyme activity is an important problem for its in vivo applications. We achieved photochemical regulation of DNAzyme activity by using reversible DNA photo-crosslinking of 3-cyanovinylcarbazole (^CNVK). The ODN containing ^CNVK photo-crosslinked to a pyrimidine base in the complementary strand after a few seconds of photoirradiation, and its photoadduct was split by photoirradiation of another wavelength. The activity of photo-crosslinked DNAzyme with ^CNVK was completely inhibited (OFF state). In contrast, after 312 nm irradiation, DNAzyme activity was recovered upon addition of a substrate strand (ON state). In addition, the photo-crosslinked DNAzyme is prone to enzymatic digestion by exonuclease. This photochemical OFF to ON switching with reversible DNA photo-crosslinking was regulated at the desired time and position; therefore, it might be possible to use it for in vivo application.     

换热网络优化中换热单元生成频次的影响分析及策略改进

换热单元的生成频次对换热网络优化有直接的影响，分析其机理可以指导求解算法的改进。本文采用节点非结构模型及强制进化随机游走算法，通过设置不同的换热单元生成概率与生成个数以改变换热单元的生成频次，观察并记录个体在优化过程中产生的年综合费用变化情况。发现不同生成频次下整型变量和连续变量的相对优化频率发生了变化，从而改变了整体优化过程，并且与个体当前优化状态不适应的生成频次会造成相对优化频率不平衡、优化结果较差。基于此，本文提出了一种具有生成参数动态调节策略的换热单元生成方式，在优化过程中根据个体状态实时调整换热单元的生成概率与生成个数，平衡整型变量与连续变量的相对优化频率。最后，采用15SP、10SP和20SP算例进行验证，换热网络的年综合费用较文献结果分别下降了1.06%、0.16%、0.68%，验证了该策略使得换热单元的生成频次更为合理，有效地提高了算法的优化效率。     

Low Frequency Electromagnetic Casting of 2195 Aluminum-Lithium Alloy and Its Effects on Microstructure and Mechanical Properties

In this study,the low frequency electromagnetic casting(LFEC) technology was adopted to fabricate 2195 Al-Li alloy.The microstructure and solid solubility of as-cast 2195 alloys,as well as the second phase precipitation and tensile properties after aging,were investiagated and compared with the counterpart direct chill casting 2195 alloy.Our results indicate that LFEC can significantly improve the microstructure and metallurgical quality of as-cast alloy,and increase the number density of θ'(Al_2 Cu) and T_1(Al_2 CuLi) phases during aging treatment due to the enhanced solubilities of alloying elements.The tensile properties of 2195 aged alloy cast by LFEC were hence improved evidently.